Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series - Manual (Page 41)

Chapter 6: Modifying Your Washer
Product Service 1-800-522-7658 37
To adjust the height of the upper rack:
1.
Remove the upper rack as described in Chapter 4: Using Your Washer.
2.
Remove the 2 nuts that retain the rack mounting plate to the slide.
3.
Reposition the rack mounting plate to the slide using the other set of holes.
Replace the 2 nuts.
4.
Repeat the procedure on the opposite slide.
Spindle Rack Options
If you purchased a FlaskScrubber Glassware Washer, you can modify the
configuration of your washer to better suit your needs. Optional accessories
include two Pipet Inserts, and an Upper Spindle Rack. The Pipet Inserts are easily
installed in place of one or more spindles in the washer and are designed to
accommodate 1 ml to 50 ml pipets.
Installing Optional Pipet Inserts in a FlaskScrubber
Two sizes of Pipet Inserts are available. The 8-place Pipet Insert, shown below
accommodates 1 ml to 10 ml pipets. Multiple Pipet Inserts may be installed, if
desired. Refer to the figure and follow the instructions below to install an 8-place
Pipet Insert.
To install an 8-place Pipet Insert:
1.
Insert the tool supplied with the Spindle Rack or a screwdriver into the top of
a spindle and turn counterclockwise to remove the spindle.
2.
In the position previously occupied by the spindle, thread into place the short
spindle you received with the Pipet Insert.
3.
Push the Pipet Insert over the short spindle.
4.
If spindles other than the one used for the short spindle are removed, the holes
must be plugged with the plastic plugs supplied with the spindle rack.