Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 45781 Series - Manual (Page 50)

Chapter 7: Troubleshooting
Product Service 1-800-522-7658 46
46
PROBLEM
CAUSE CORRECTIVE ACTION
Purified water does
not fill Crimp in supply hose Refer to installation instructions for proper
purified water piping installation.
Motor wires
disconnected Reconnect wires.
Tank and inner
door have surface
rust Collects normally Clean with stainless steel cleaner and soft cloth.
Glassware is
contaminated with
mineral acids. Pre-rinse glassware. Clean with stainless steel
cleaner and soft cloth.
Washer does not
run No power to washer Check fuse or circuit breaker, or door switch.
Door latch is open Latch washer door by pushing door in.
Washer door opens
and closes badly Cabinet opening is not
square Correct opening with leveling feet.
Door hitting counter-
top mounting screws Adjust mounting screws.
Washer leaks Washer is not level Adjust leveling feet.
Door not sealing Adjust door latch.
Tank gasket loose Check gasket and correct.
Loose connection at
hose clamps Tighten hose clamp.
Loose connection at
fill valve Check fill valve and correct.
Improper detergent Use non-foaming detergent. Use only proper
amount of detergent.
Obstruction in drain
line Remove obstruction.
Washer overfilling Check operation of fill switch.
Washer leaks
around door seal Improper installation Check cabinet opening to see if it is aligned
properly with the door. Washer must be level.
Adjust feet to level unit.
Unit not level Adjust feet to level unit.
Door opened during
operation Allow 4-5 seconds before opening door after
unlatching.