MOCET IP3092 User Manual
Page 9
Page 9
MOCET IP3092/IP3092L Communicator User Guide
1.3.1. Connect the Handset to the Communicator:
After unpacking the box, place the Communicator on the table and turn its stand to a
proper angle (for example, 45º).
Then connect the handset to the curly handset cord first and plug the other end of the cord
to the phone jack marked HAND
on the rear panel of the Communicator. Please refer to
the following figure below.
1.3.2. Connect the Ethernet cable:
If you plan to use IP Commander mode with a VoIP service or an IP PBX, connect the
Communicator to your LAN or Internet router with the included CAT-5 Ethernet cable on its
LAN port
,
To eliminate the requirement for multiple Ethernet cables to a user’s location, the user’s
computer can be connected to the network through the second Ethernet PC port
on
the Communicator if desired.
1.3.3. Connect the power:
Then plug the barrel plug of the included power adapter to the port
marked 12VDC.
Please make sure you use the right power adapter. It shall have a label showing 12V
and 2A.