Altera Stratix IV GX FPGA - Manual (Page 21)

Chapter 4: Development Board Setup 4–5
Factory Default Switch Settings
March 2014 Altera Corporation Stratix IV GX FPGA Development Kit User Guide
5. Set DIP switch bank (SW6) to match Table 4–4 and Figure 4–2 .
f For more information about the FPGA board settings, refer to the Stratix IV GX FPGA
Development Board Reference Manual .
Table 4–4. SW6 Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1 EPM2210_JTAG_EN
Switch 1 has the following options:
■ When on, the MAX II device is not included in the JTAG chain.
■ When off, the MAX II device is included in the JTAG chain.
Off
2 HSMA_JTAG_EN
Switch 2 has the following options:
■ When on, HSMA is not included in the JTAG chain.
■ When off, HSMA is included in the JTAG chain.
On
3 HSMB_JTAG_EN
Switch 3 has the following options:
■ When on, HSMB is not included in the JTAG chain.
■ When off, HSMB is included in the JTAG chain.
On
4 PCIE_JTAG_EN
Switch 4 has the following options:
■ When on, PCI Express is not included in the JTAG chain.
■ When off, PCI Express is included in the JTAG chain.
On