Components and interfaces, Pci express, Components and interfaces –27 – Altera Arria II GX FPGA Development Board, 6G Edition User Manual

Page 35: Pci express –27

Advertising
background image

Chapter 2: Board Components

2–27

Components and Interfaces

© July 2010 Altera Corporation

Arria II GX FPGA Development Board, 6G Edition Reference Manual

Table 2–32

lists the LCD component references and the manufacturing information.

Components and Interfaces

This section describes the development board's communication ports and interface
cards relative to the Arria II GX device. The development board supports the
following communication ports:

PCI Express

10/100/1000 Ethernet

HSMC

PCI Express

The Arria II GX FPGA development board, 6G Edition is designed to fit entirely into a
PC motherboard with a ×8 PCI Express slot that can accommodate a full height long
form factor add-in card. This interface uses the Arria II GX device's PCI Express hard
IP block, saving logic resources for the user logic application.

f

For more information on using the PCI Express hard IP block, refer to the

PCI Express

Compiler User Guide

.

The PCI Express interface supports auto-negotiating channel width from ×1 to ×4 to
×8 as well as the connection speed of Gen1 at 2.5 Gbps/lane for a maximum of
20 Gbps full-duplex.

The power for the board can be sourced entirely from the PCI Express edge connector
when installed into a PC motherboard. Although the board can also be powered by a
laptop power supply for use on a lab bench, it is not recommended to power from
both supplies at the same time. Ideal diode power sharing devices have been
designed into this board to prevent damages or back-current from one supply to the
other.

4

RS

H/L

Register select signal

H: Data input

L: Instruction input

5

R/W

H/L

H: Data read (module to MPU)

L: Data write (MPU to module)

6

E

H, H to L

Enable

7–14

DB0–DB7

H/L

Data bus, software selectable 4-bit or 8-bit mode

Table 2–31. LCD Pin Definitions and Functions (Part 2 of 2)

Pin

Number

Symbol

Level

Function

Table 2–32. LCD Component References and Manufacturing Information

Board

Reference

Description

Manufacturer

Manufacturer

Part Number

Manufacturer

Website

J3

2×7 pin, 100 mil, vertical header

Samtec

TSM-107-01-G-DV

www.samtec.com

2×16 character display, 5×8 dot matrix

Lumex Inc.

LCM-S01602DSR/C

www.lumex.com

Advertising