Subaru 2004 Legacy - Manual (Page 232)

5-31
Audio
– CONTINUED –
V Tone control
The volume control dial (7) normally function as vol-
ume control. The dial become a control for Bass or
Treble when you select the appropriate tone control
mode.
Choose desired level for each mode by turning the vol-
ume control dial. The control function returns to vol-
ume control mode after about 5 seconds.
To change control modes: Each brief press of the
“BASS/TREB” button (8) changes control modes in
the following sequence starting from bass control
mode. (When the radio is first turned on, the control
mode is in the volume control.)
V Fader and balance control
The volume control dial (7) normally function as vol-
ume control. The dial become the controls for Fader or
Balance when you select the appropriate fader and
balance control mode.
Choose desired setting for each mode by turning the
volume control dial. The control function returns to vol-
ume control mode after about 5 seconds.
To change control modes: Each brief press of the
“FAD/BAL” button (6) changes control modes in the
following sequence starting from fader control mode.
(When the radio is turned on, the control mode is in the
volume control.)
V Display illumination dimness cancellation
(BRIGHT)
The brightness of the radio display dims when the light
switch is in the “ ” or “ ” positions. If this
makes the display difficult to read, press the dial (7) for
more than two seconds to return the display to original
brightness.
Subsequently pressing the dial (7) again for more than
two seconds or if you can safely do so, turning the light
switch to the OFF position and back to the “ ” or
“ ” position makes the radio display dim again.
T FM/AM selection button
Press the “FM/AM” selection button (1) to choose ei-
ther FM or AM broadcasts. The display will show FM
or AM accordingly.
Use the tuning dial to select the station to which you
Volume
(VOL) Bass
(BASS) Treble
(TREB)
Volume
(VOL) Fader
(FAD) Balance
(BAL)