NISSAN 2009 Frontier User Manual

Page 133

Advertising
background image

WARNING

Drive extra carefully when the vehicle is

loaded at or near the cargo carrying

capacity, especially if the significant

portion of that load is carried on the

roof rack.

Heavy loading of the roof rack has the

potential to affect the vehicle stability

and handling during sudden or abnor-

mal handling maneuvers.

Roof rack load should be evenly

distributed.

Do not exceed maximum roof rack load

weight capacity.

Properly secure all cargo with ropes or

straps to help prevent it from sliding or

shifting. In a sudden stop or collision,

unsecured cargo could cause personal

injury.

CAUTION

Use care when placing or removing items

from the roof rack. If you cannot comfort-

ably lift the items onto the roof rack from

the ground, use a ladder or stool.

Always evenly distribute the cargo on the tubular

roof rack. The maximum total load is 125 lb

(56 kg) evenly distributed. Be careful that your

vehicle does not exceed the Gross Vehicle

Weight Rating (GVWR) or the Gross Axle

Weight Ratings (GAWR front and rear). The

GVWR and GAWR are located on the F.M.V.S.S.

label (located on the driver’s side door jamb

pillar). For more information regarding GVWR

and GAWR, refer to “Vehicle loading information”

in the “Technical and consumer information” sec-

tion later in this manual.
The front crossbar can be adjusted or removed.

Use the Torxdriver provided in the tool kit to

loosen both crossbar adjusting screws.
To adjust:

1. Loosen the adjusting screws with the

Torxdriver

1

by turning counterclockwise

A

.

2. When the clamp is loosened, move the

crossbar so the cargo can be positioned on

the crossbar

B

.

3. Tighten the crossbar adjusting screws with

the Torxdriver by turning clockwise.

4. Secure the cargo with rope.
5. Always check the tightness of the crossbar

adjusting screws.

To remove:

1. Loosen the adjusting screws with the

Torxdriver

1

by turning counterclockwise

A

.

2. Rotate the clamps

C

.

3. Remove the crossbar.
4. Reverse to install.
5. Always check the tightness of the crossbar

adjusting screws.

If you hear wind noise coming from the roof rack

while driving, adjust the roof rack crossbar to the

neutral position, rearward of

⌬ on the side rails.

Instruments and controls

2-45

REVIEW COPY—

2009 08+ Truck/Frontier (fro)

Owners Manual—USA_English (nna)
05/27/08—debbie

Advertising