NISSAN 2009 Frontier User Manual

Page 224

Advertising
background image

● Make sure the area around the vehicle is

clear.

● Check fluid levels such as engine oil, cool-

ant, brake fluid, and window washer fluid as

frequently as possible, or at least whenever

you refuel.

● Check that all windows and lights are clean.
● Visually inspect tires for their appearance

and condition. Also check tires for proper

inflation.

● Check that all doors are closed.
● Position seat and adjust head restraint.
● Adjust inside and outside mirrors.
● Fasten seat belts and ask all passengers to

do likewise.

● Check the operation of warning lights when

the ignition switch is turned to the ON (3)

position. See “Warning/indicator lights and

audible reminders” in the “Instruments and

controls” section of this manual.

1. Apply the parking brake.
2. Automatic transmission:

Move the shift selector to P (Park) or N

(Neutral). P (Park) is recommended.
The shift selector cannot be moved out

of P (Park) and into any of the other

gear positions if the ignition key is

turned to the OFF position or if the key

is removed from the ignition switch.
The starter is designed not to operate if

the shift selector is in any of the driving

positions.
Manual transmission:
Move the shift selector to N (Neutral). De-

press the clutch pedal to the floor while

cranking the engine.
The starter is designed not to operate

unless the clutch pedal is fully de-

pressed.

3. Crank the engine with your foot off the

accelerator pedal by turning the ignition

switch to START. Release the key when the

engine starts. If the engine starts, but fails to

run, repeat the above procedure.

● If the engine is very hard to start in ex-

tremely cold weather or when restarting,

depress the accelerator pedal a little (ap-

proximately 1/3 to the floor) and hold it

and then crank the engine. Release the

key and the accelerator pedal when the

engine starts.

● If the engine is very hard to start because it

is flooded, depress the accelerator pedal

all the way to the floor and hold it. Crank

the engine for 5-6 seconds. After cranking

the engine, release the accelerator pedal.

Crank the engine with your foot off the

accelerator pedal by turning the ignition

key to START. Release the key when the

engine starts. If the engine starts, but fails

to run, repeat the above procedure.

CAUTION

Do not operate the starter for more than

15 seconds at a time. If the engine does

not start, turn the key off and wait 10

seconds before cranking again, otherwise

the starter could be damaged.

4. Allow the engine to idle for at least 30 sec-

onds after starting. Do not race the engine

while warming it up. Drive at moderate

speed for a short distance first, especially in

cold weather.

BEFORE STARTING THE ENGINE

STARTING THE ENGINE

5-12

Starting and driving

REVIEW COPY—

2009 08+ Truck/Frontier (fro)

Owners Manual—USA_English (nna)
05/27/08—debbie

Advertising