Optoma X307USTi - Manual (Page 48)

48
English
Appendices
Two images, Side-by-Side(Half) format
Select “3D” --> “3D Format” from OSD and choose “Side-by- ` `
Side(Half)” for input signal is HDMI 1.4a 3D. 3D Format is only
supported on 3D Timing on page 54.
Image does not display in 3D
Check if the battery of 3D glasses is drained. ` `
Check if the 3D glasses is turned on. ` `
Select “3D” --> “3D Format” from OSD and choose “Side-by- ` `
Side(Half)” for input signal is HDMI 1.4a 3D. 3D Format is only
supported on 3D Timing on page 54.
On Screen Messages
Power off confirm ` `
Power Off?
Press power key again.
Fan lock error ` `
The proejctor will switch off automatically.
Warning! FAN LOCKED
No source found ` `
VGA 1
No Source Found
Out of display range ` `
VGA
Out of display range
Over temperature ` `
Warning! TEMPERATURE TOO HIGH
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 40 degree C.