BINDER MK 53 - Manual (Page 22)

MK (E2.1) 10/2014 page 22/73
5. Start up
After connecting the electrical supply (chap. 4), turn on the unit by the main power switch (2).
Warming chambers may release odors in the first few days after commissioning. This is not a quality de-
fect. To reduce odors quickly we recommend heating up the chamber to its nominal temperature for one
day and in a well-ventilated location.
5.1 Function overview of display program controller MB1
Pilot lamp: Ready for operation
EXIT button (to exit a menu point)
AUTOMATIC button (to start a previously entered program)
ENTER button (to confirm a selection)
Navigation buttons (functions are assigned by the menu)
Main power switch (2)
Figure 6: Display program controller MB1
The program controller MB1 controls the temperature inside the alternating climate chamber.
You can enter the desired set point values in Manual Mode or Program Mode (chap. 5.2) in the display
controller.
W X
08:43:55 15.12.05
CONFIG VIEW-> PGM
TEMP
40.0
36.8
°C
HAND
Set point value Actual value
Figure 7: Normal display of the MB1 program controller in Manual mode