BINDER MK 53 - Manual (Page 63)

MK (E2.1) 10/2014 page 63/73
18.4 Technical Data MK 53 (E2.1)
Exterior dimensions
Width (including access port 80 mm with plug)
mm / inch 745 / 29.33
Height (feet included) mm / inch 1245 / 49.02
Depth (including 55 mm controller and door handle) mm / inch 795 / 31.30
Wall clearance sides mm / inch 160 / 6.30
Wall clearance rear mm / inch 100 / 3.94
Window width mm / inch 280 / 11.02
Window height mm / inch 280 / 11.02
Interior dimensions
Width
mm / inch 402 / 15.83
Height mm / inch 402 / 15.83
Depth mm / inch 330 / 12.99
Interior volume l / cu.ft. 53 / 1.9
Number of racks ( standard / max.) 1/5
Load per rack Kg / lbs. 15 / 33
Permitted total load Kg / lbs. 40 / 88
Temperature data
Temperature range
°C / °F -40 to +180
Temperature uniformity (variation) ± K 0.4 to 2.0
Temperature fluctuation ± K 0.1 to 0.5
Recovery time after door was
opened for 30 sec 1)
at -10 °C minutes 5
at + 70 °C minutes 1
at +150 °C minutes 5
Average heating up time from -40 °C to 180 °C K/min. 4.6
Average cooling down time from 180 °C to -40 °C K/min. 4.1
Max. heat compensation W 500
Electrical data
IP-system of protection acc. to EN 60529
IP 20
Nominal voltage (+10%) 50 Hz V 230 1N~
Power plug shockproof plug
Over-voltage category acc. to IEC 61010-1 II
Pollution degree acc. to IEC 61010-1 2
Nominal power kW 2.60
Energy consumption 2) at 20 °C / 68 °F Wh/h 1020
Further information
Weight (empty)
Kg / lbs. 150 / 331
Filling weight of refrigerant Kg / lbs. 0.85 / 1.87
Noise level approx. dB(A) 59
1) to 98% of the set value
2) These values can be used for dimensioning air condition systems.
All technical data is specified for unloaded units with standard equipment at an ambient temperature of
+25 °C / 77 °F and a power supply voltage fluctuation of ±10. The temperature data is determined in ac-
cordance to BINDER factory standard following DIN 12880, observing the recommended wall clearances
of 10 % of the height, width and depth of the inner chamber. Technical data refers to 100% fan speed.
All indications are average values, typical for units produced in series. We reserve the right to
change technical specifications at any time.