Casella CEL Software for the Tuff sampling pumps - Manual (Page 8)

4. OPERATION
A. POWER ON
Note:
To Set Language go to Configuration Chapter 5 .
To start the pump, press and release the ON/OFF Key. The Firmware will run through
the initialisation screens and then automatically go to the Main Menu.
Figure 4 Power ON Screens
B. MAIN MENU
(Fig. 5)
When on the Sampler will scroll through the Main Menu Options. The information
displayed on the screens will be the saved data from the last time the pump was used.
Press the ENTER key on any screen to start the pump.
(Volume and Flow not
displayed on Standard Model.)
Figure 5 Main Menu
C. RUN MODE MAIN MENU (Fig. 6)
When the pump is running the Sampler will scroll through the Run Mode Menu options
and the blue led will be flashing. Current run data will be displayed. To stop the pump,
press and hold the ENTER key on any screen until the countdown is complete.
Note: PRO Model Only -
Screen (Z) is the remaining run time available based on the
current flow and pressure loading. The Plus model displays the % of remaining battery
capacity only. Standard model only displays battery status bar and elapsed run time
only. No flow rate or sampled volume are displayed.
Figure 6 Run Mode Main Menu
D. STOPPED MODE MENU OPTIONS
(Fig. 7)
Use the UP/DOWN keys to step through the Menu Options. Press ENTER to access a
Menu Option when it is displayed. Menu option not available in partial lock mode.
Figure 7 Menu Options
Casella CEL Limited 8