Adept DeskTop 4.3 - Manual (Page 72)

Adept DeskTop 4.3 - Online Help 72
Operations Manager
The Operations Manager tool allows an administrator-level user to configure operations that can later
be run from the Operator Control.
• The operations configured and managed through the Operation Manager are operations that
are typically executed by an operator in a workcell. The only possible actions that can be
carried out on these operations from the Operator Control are START, Proceed, PAUSE and
STOP. See
Operator Control .
• The STOP and PAUSE buttons for a defined operation can be optionally enabled or disabled in
the Operation Editor.
• The grid in the Operation window displays all the currently available operations, as illustrated
in Figure 45 .
To open the Operations Manager:
1. From the Adept DeskTop menu, select Tools > Operations Manager.
2. The Operation Manager window opens, as illustrated in Figure 45 . This is a modal window: you
cannot return to the main interface while it is open.
Figure 45 Operations Manager Window
Add
Opens a blank Operation Editor form in which you can configure a new operation to add to the current
list. See
Operation Editor .
Remove
Removes the a selected operation from the list of operations.
Edit
Opens the Operation Editor, containing the current settings of the selected operation. See Operation
Editor .
Note:The Operation Manager is only available if you are logged into Adept
DeskTop with the administrator (top-level) Access Level.