Water heater location – AquaMAX G135VE User Manual
Page 21
21
WATER HEATER LOCATION
The water heater should be installed close to the most frequently used outlet and
its position chosen with safety and service in mind. Make sure people
(particularly children) will not touch the flue outlet. The flue terminal must be clear
of obstructions and shrubbery.
Clearance must be allowed for servicing of
the water heater. The water heater must be
accessible without the use of a ladder or
scaffold. Make sure the temperature
pressure relief valve lever is accessible and
the front cover and burner can be removed
for service.
If possible leave headroom of one water
heater height so the anode can be inspected
or replaced. Remember you may have to
remove the entire water heater later for
servicing.
The water heater is to be installed at ground or floor level on a stable fireproof
base as acceptable to local authorities. The water heater must also stand
vertically upright with the back of the water heater against or within 25 mm of
an external wall or alternatively against a fireproof screen extending at least
500 mm above, below and either side the flue terminal. Failure to observe this
precaution can cause problems in high wind areas.
Alternatively, the water heater may be installed partially recessed into an external
wall. A recessed installation kit is available from Aquamax.
A secondary flue is not required.
It is a requirement of AS 5601 and AS/NZS 5601.1 to secure the water heater to
the wall. The top of the unit is to be secured to the wall or screen with the wall
brackets provided using fasteners suitable for the wall or screen type and
application. Refer to
on page 23.
The water heater must not be installed in an area with a corrosive atmosphere
where chemicals are stored or where aerosol propellants are released.
Remember the air may be safe to breathe, but when it goes through a flame,
chemical changes take place which may attack the water heater.