Artesyn ViewCheck on ATCA-7370 Installation and Use (April 2014) - Manual (Page 35)

Installation of ViewCheck
ViewCheck on ATCA-7370 Installation and Use (6806800S48B) 35
3. Type your username and password.
Username: Admin
Password:
Access granted
>enable
#configure terminal
BSF(config)#
BSF(config)#virExecEnv vee0
BSF(VEE-vee0)#diagnostic
BSF(diag-vee0)#
After logging into the ViewCheck CLI, you can list all the commands supported by typing '?'
on the CLI console. For information on commands to be used to install and LOG to ViewCheck,
refer
Commands Execution on page 51 .
BSF(diag-vee0)#?
device-category Configure device Category
exit Exit from diagnostic
hw-inventory-list Provides the Inventory of Hardware (Type,
Vendor ID, Major Number, Minor Number and any
associated Details) as detected by the
Diagnostics Application.
purge-all-log All log files are Zipped and stored away.
purge-log Purge specific log file.
set-log-level Sets the Log Level of Diagnostic
Application.
show-log-info List all Log files of Diagnostics
Application.
show-systemerror-log show system error log.
You can enter into device category mode by giving the command device-category on CLI
and view the list of commands only supported at device category level.
By default, the administrator user name and password are "Admin".