Artesyn ViewCheck on ATCA-7370 Installation and Use (April 2014) - Manual (Page 81)

Commands Execution
ViewCheck on ATCA-7370 Installation and Use (6806800S48B) 81
5.6.3 Memory
 MemCntlrTest: Randomly writes to areas of memory, then reads the memory back to
ensure the values written remain unchanged.
 RandomMemoryTest: Performs stress-testing on the memory subsystem. This test is
effective in finding intermittent and non-deterministic faults. The problems in other
hardware areas such as overheating CPU, out-of-specification power supply, and so on can
cause memory faults.
5.6.4 OS
 MemSepTest: Ensures that user space programs cannot read and write to areas of memory
utilized by items such as Video RAM and kernel code.
 SupervisorInstrTest: Ensures that the enforcement of the property that privileged
instructions should only be in supervisor mode is still in effect. The set of privileged
instructions tested to confirm this is architecture dependent.
5.6.5 PCI
 PCIScanTest: Enumerates all active PCI devices in the blade and ensures board default
configuration is active. This test need to be executed under supervisory mode.
5.6.6 IPMC
IPMITest: Executes basic IPMI commands and ensures the basic IPMI controller, IPMI bus
functionalities are working properly by reading the response back.
Executing this test in user mode may result in failure of test.
Executing this test with the supported RTMs except ARTM-736X may result in failure of test.