Artesyn System Management Interface Based on HPI-B 2.0(Centellis 4620/4440) User's Guide (June 2014) - Manual (Page 19)

Chapter 2
System Management Interface Based on BBS HPI-B 2.0 (Centellis 4620/4440) User’s Guide (6806800P21D) 19
Software Installation and Configuration
2.1 Overview
This section describes how to set-up HPI-B daemons and clients and how to install all files
needed to run client applications. Generally, all files are delivered in the form of RPMs. The
content of an RPM is reflected in its naming scheme.
The following table describes the used naming scheme of the client and daemon RPMs. The
placeholder "architecture" stands for the supported CPU architecture of the respective blade
where the client or daemon is to run and the following boards or architectures should be
referred as example:
 x86
Intel IA-32 bit blades, such as PrAMC-7210/7211
 x86_64
Intel IA-64-bit blades, such as the ATCA-7221
 ppc_e500v2
PowerPC based blades, such as the ATCA-F125/F140
The files required for the HPI-B daemon come as part of the ATCA-F125/F140 software.
Depending on the particular ATCA-F125/F140 release, the HPI-B daemon files are already
preinstalled or not. Check the respective documentation of the ATCA-F125/F140 itself and of
the system where the ATCA-F125/F140 is used.
If the HPI-B software is not preinstalled or if you want to upgrade the installed HPI-B software,
then you can obtain the daemon files as an RPM file. The file can be obtained from Artesyn.
Table 2-1 RPM Files for HPI-B Clients and Daemons
RPM File Name Description
bbs-hpib-<version>-
1.<architecture>-
<distribution>-<OS>.rpm
This RPM is the HPI-B base package. It contains shared
libraries to be used by HPI-B clients and daemons, as well as
compiled example applications and client configuration
files. This package is required both by HPI-B daemons and
clients.
bbs-hpib-daemon-<version>-
1.<architecture>-
<distribution>-<os>.rpm
.
This RPM contain all files which are related to the HPI-B
daemon: executables, libraries and configuration file.