Artesyn System Management Interface Based on HPI-B 2.0(Centellis 4620/4440) User's Guide (June 2014) - Manual (Page 51)

Using HPI-B
System Management Interface Based on BBS HPI-B 2.0 (Centellis 4620/4440) User’s Guide (6806800P21D) 51
If the domain/shelf specified in the call exists, the domain/shelf is removed, an HPI domain
removed event is generated and any sessions that may be open to this domain are closed.
Furthermore the domain shelf resource in the HPI domain is removed and a hot swap even of
type "NOT_PRESENT" is generated.
4.5 Using the SNMP Agent
Once the SNMP agent is installed and configured as described in Installing and Configuring an
SNMP Agent on page 31 , you can start/stop the SNMP subagent and master agent as described
below.
To start/stop the SNMP subagent, enter # /etc/init.d/hpibsnmp < start > or
<stop>
on the ATCA-F125/F140.
To start/stop the SNMP master agent, enter # /etc/init.d/snmpd start|stop
To check if the SNMP mast is running, enter: # ps -aux | grep snmp
If it is running, the following should be displayed: /usr/sbin/snmpd -Lsd -Lf
/dev/null -p /var/run/snmpd.pid
.
For a detailed description of the SAI-HPI-B.01.01 MIB refer to the respective specifications
which can be downloaded from the Service Availability Forum’s website at
http://www.saforum.org .
CtrlState
Pointer to control state as described in Table
"Domain Management Control State" on page 45 .
In this control state, fill the field body as follows:,
[0] : 2 (stands for "remove domain")
[1] - [4] : IP address of shelf you want to add (little
endian order)
[5] - [6] : port of shelf (little endian order)
[7] - [n] : Domain name
Parameter Value