Artesyn System Management Interface Based on HPI-B 2.0(Centellis 4620/4440) User's Guide (June 2014) - Manual (Page 27)

Software Installation and Configuration
System Management Interface Based on BBS HPI-B 2.0 (Centellis 4620/4440) User’s Guide (6806800P21D) 27
ResourcePowerOnTimeout
A timeout after which the
resource FRU Power State
will be set to initial state.
This timer is started soon
after executing the Power
On/hotswap operations
on the resource.
<0…N> [20000] - 20000 ms 20000
unsolicited_events
Subscription for
asynchronous event
notification from the shelf
manager
"yes | no" [yes]
- Subscribe for
"AsyncEventNotification" from
the Shelf Manager
no
- Do not subscribe for
"AsyncEventNotification" from
the Shelf Manager
no
clear_sel
Clear the SEL after reading
events from it
"yes | no" [no]
- Do not clear the SEL
yes - clear the SEL
no
RmcpEnable
Enables/disables the
RMCP server
"true | false" [false]
- disables the rmcp
server
true
- enables the rmcp server
false
RmcpPort
Port on which RMCP
service runs
Standard port [623] 623
RmcpMaxConnection
Maximum number of
connections active. After
this count is reached, any
new connections are
rejected
<0…N> [11] - 11 connections 10
RmcpConnectionTimeout
RMCP connection
timeout
<0…N> [60000] - 60000 msecs 60000 msecs
RmcpSessionTimeout
RMCP Session Timeout
<0…N> [60000] - 60000 msecs 60000 msecs
RmcpPefAlerting
RMCP PEF alerting
"true | false" [true]
- supports PEF alerting
false
- does not support
false
RmcpPerMsgAuth
RMCP per msg
authentication
"true | false" [true]
- authentication
supported
false
RmcpPrivLimit Privilege needed for using
RMCP service
"callback |
user | operator
| admin"
[admin] - highest
privilege admin
RmcpAllowedAuthsCallback
Allowed authentication
mechanisms for privilege
level 'callback
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpAllowedAuthsUser
Allowed authentication
mechanisms for privilege
level 'user
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpAllowedAuthsOperator
Allowed authentication
mechanisms for privilege
level 'operator
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
Table 2-4 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default