Avalon Firestyles 564 Diamond-Fyre GSR2 Installation - Manual (Page 48)

48 Finalizing the Installation
(for qualified installers only)
© Travis Industries 4140926 100-01395
9. Check the air shutter following the directions below.
Air Shutter Adjustment
Let the heater burn for fifteen minutes (make sure the crushed glass and glass frame are in place). The
flames should be yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking
flame.
10. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check
the flame on low position. The flames should burn off of each burner hole. If the heater does not
work correctly, contact your Travis dealer for a remedy.
11. Give this manual to the home owner for future reference and fully explain operation of this heater.
For comprehensive operating and maintenance instructions, refer to the Owner's Manual (part #
100-01365).
ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been treated with acid wash has
been properly neutralized (this is used primarily with brick faces). Acid wash (muriatic acid) is used to remove excess mortar.
If not properly neutralized with an ammonia solution, the plated face may develop a permanent tarnish when the acid
evaporates over time. Contact your dealer if uncertain your facing has been properly neutralized.
Correct
Flames should be blue at the
base, yellow-orange on the top. If the flames are too tall or sooty on the
ends, open the air shutter.
Not Enough Air
If the flames are all blue and
short, close the air shutter.
Too Much Air
Gas Control Valve
Burner Air Shutter Control
Forward = More Air
Backward = Less Air
Adjusting the Air Shutter