Baby Lock Evolve (Previous Model) (BLE8W) Instruction and Reference Guide - Manual (Page 10)

O
V
E
R
V
I
E
W
8
Setting Up Your evolve
1. Remove machine from box
After removing the packing materials from the box,
gently lift your Baby Lock serger by grasping the han-
dle provided on the top of the machine. Place the
machine on a serger sewing table or any level surface
that provides ample work area to the left. Place the foot
controller in a pedal stay, if desired, and place it under
the sewing table.
2. Plug in the machine
Plug the power cord into the machine first, then into a
wall outlet. The power switch is located toward the
back on the right side of the machine. Always make
sure the power is off when the machine is not in use (fig.
A). Available foot controller for U.S.A.: Model YC-482
or YC-420W.
3. Polarized plug
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electri-
cian to install the proper outlet. Do not modify the plug
in any way.
4. Foot controller
The sewing speed of the machine is determined by the
amount of pressure applied to the foot controller. When
not in use, do not place anything on the foot controller,
or the machine could start inadvertently and the con-
troller or motor could burn out.
5. Spool pin extension table
To insert the spool pin extension:
Place the pegs into the slots on the back of the main
thread spool stand.
Push the extension thread stand onto the main thread
spool stand until it snaps into place (fig. B).
To remove:
Hold the back of the extension table with both hands.
Raise it up and out to release from the main thread
spool stand (fig. C).
A
B
C