Baby Lock Evolve (Previous Model) (BLE8W) Instruction and Reference Guide - Manual (Page 34)

The rolled edge setting is used to achieve the narrowest stitch possible (1.5mm) on your Baby Lock serger.
The stitch is suitable for seaming sheer and lightweight fabrics and for edging and hemming lightweight
fabrics.
O
V
E
R
L
O
C
K
S
T
E
X
P
R
E
S
S
32
Rolled Edging
3-Thread Rolled Edge
With the stitch selector set on "D", a narrow hem can become a rolled edge. The fabric edge rolls around the
stitch finger. The upper looper wraps the fabric edge while the lower looper thread is nearly invisible on the
back side of the stitch formation.
Remove the 0-1 needle and thread. Clear the stitch fingers. Turn the stitch length adjusting dial clockwise
into the rolled hem range and set the dial at 1.5 (fig. A). Set the stitch width dial to 3.5 "M" (fig. B).
For a 3-thread rolled edge, Move the stitch selector lever to "D".
NEEDLES
O-2
LENGTH
1.5R
WIDTH
3.5
STITCH
SELECTOR
D
WAVE
SELECTOR
O