Baby Lock Evolve (Previous Model) (BLE8W) Instruction and Reference Guide - Manual (Page 69)

1. Stitch along one edge until you reach the corner. Take one stitch off
the edge of the fabric (fig. A). (As you approach the edge, you may
want to stop and manually turn the handwheel towards you.)
2. Raise the needle(s) to the highest position.
3. Clear the stitch fingers, and rotate the fabric to reposition the needle
at the previous row of stitching (fig. B). Gently pull up on all threads
to remove slack and resume stitching (fig. C).
Note: A loose thread loop at the corner is caused by too much slack in
the needle thread when clearing the stitch fingers. Try again, turn-
ing corners takes a little practice!
T
E
C
H
N
I
Q
U
E
S
67
A
B
C
Turning Inside Corner - Overlock
Turning Outside Corner - Overlock
1. Reinforce loosely woven fabrics at the corner with staystitching on the
conventional sewing machine. Clip to the corner (fig. A).
2. Align the fabric edge with the blade, and stitch until the blade reach-
es the corner, not the needles. Don't cut into the corner (fig. B).
3. Lower the needle(s) to anchor the fabric.
4. Raise the presser foot and straighten out the fabric, forming a pleat
at the corner (fig. C).
5. Be sure the marked stitching line is straight, then continue serging the
remaining edge. When done correctly, the pleat will disappear after
stitching (fig. D).
A
B
C D