Baby Lock Evolve (Previous Model) (BLE8W) Instruction and Reference Guide - Manual (Page 24)

Left Chain/Cover Needle C-1
1. Raise presser foot, place the thread on the "Chain Needle 1" spool pin. Slip the thread into the telescopic
antenna thread guide "C1" directly above the spool. See drawings below for reference.
2. Bring thread down from the telescopic antenna thread guide into the far left chain/cover needle thread guide
"C1". Then insert thread into "C1" slot until thread clicks in. This seats the thread into the tension. Bring the
thread behind the front thread guide, up, over and down the right side of the thread take up lever.
3. Insert "C1" thread into pre-tension thread guide on needle clamp and into thread guide above the needle.
See drawings below for reference.
4. With the needle threader or tweezers in the accessory compartment, thread needle in "C1" position.
Center Chain/Cover Needle C-2
1. Raise presser foot, place the thread on the "Chain Needle 2" spool pin. Slip the thread into the telescopic
antenna thread guide "C2" directly above the spool. See drawings below for reference.
2. Bring thread down from the telescopic antenna thread guide into the center chain/cover needle thread guide
"C2". Then insert thread into "C2" slot until thread clicks in. This seats the thread into the tension. Bring the
thread behind the front thread guide, up, over and down the right side of the thread take up lever.
3. Insert "C2" thread into pre-tension thread guide on needle clamp and into thread guide above the needle.
See drawings below for reference.
4. With the needle threader or tweezers in the accessory compartment, thread needle in "C2" position.
Right Chain/Cover Needle C-3
1. Raise presser foot, place the thread on the "Chain Needle 3" spool pin. Slip the thread into the telescopic
antenna thread guide "C3" directly above the spool. See drawings below for reference.
2. Bring thread down from the telescopic antenna thread guide into the far right chain/cover needle thread guide
"C3". Then insert thread into "C3" slot until thread clicks in. This seats the thread into the tension. Bring the
thread behind the front thread guide, up, over and down the right side of the thread take up lever.
3. Insert "C3" thread into pre-tension thread guide on needle clamp and into thread guide above the needle.
See drawings below for reference.
4. With the needle threader or tweezers in the accessory compartment, thread needle in "C3" position.
T
H
R
E
A
D
I
N
G
22
Chain / Cover Needles
C1
C2
C3
C1 C2 C3