Baby Lock Evolve (Previous Model) (BLE8W) Instruction and Reference Guide - Manual (Page 28)

T
H
R
E
A
D
I
N
G
26
Clearing the Stitch Width Fingers
A
B C
Re-threading Loopers
If a thread breaks, raise the presser foot and pull the broken thread from under the foot. Open the front cover,
depress the machine lock button and set the looper threader selector to U, L, or C for the looper being thread-
ed. Re-thread the machine above the threading port, leaving an 18inch (40cm) thread tail. Thread the loop-
er as usual and move lock button release lever to the right. Close the front cover and sew a test sample.
Note: When re-threading your Baby Lock evolve using the "Jet-Air Threading" feature, make sure that the pre-
vious thread that was in the looper (tube) is completely removed. This will eliminate any chance of the previ-
ous thread obstructing the flow of the air when re-threading the machine.
As you sew, you will discover that maneuvering the fabric is different from
conventional sewing because the threads form around the stitch fingers
(fig. A).
To clear the stitch fingers, simply raise the presser foot, which releases all
threads. Raise the needle(s). Then pull the threads gently from behind the
foot (fig. B). The stitches are now released from the fingers (fig. C).