Loading position, Inserting the bobbin, Ab c d – Baby Lock Sashiko 2 (BLQK2) Instruction and Reference Guide User Manual
Page 19
G
E
T
T
I
N
G
R
E
A
D
Y
18
Loading Position
1. Hold the bobbin case with one hand. Insert the fully wound bobbin
into the bobbin case so that the bobbin turns in a clockwise direc-
tion. (Fig. A)
2. Pull the thread through the slot of the bobbin case. (Fig. B)
3. Slide the bobbin thread toward the left so the thread enters under
the tension spring and through the cut out area directly above the
bobbin case double-eye thread guides. (Fig. C)
4. Insert the end of the bobbin thread from right to left through the
bobbin case double eye thread guides. (Fig. D)
5. Pull out approximately 10” (25cm) of bobbin thread.
6. Press and hold the positioning button for approximately 2 seconds
to set the machine to the bobbin loading position.
7. Hold the bobbin case by the hinged latch. Align the double eye
thread guides of the bobbin case at a seven o'clock position.
(Fig. E)
8. Insert the bobbin case and rotate the bobbin case counterclockwise
so the double eye thread guide is in alignment with the groove
(yellow dot marking) of the shuttle race. Insert the bobbin case fully
into the shuttle race and release the latch. (Fig. F)
A
B
C
D
Inserting the Bobbin
Press and hold the positioning button for approximately 2 sec-
onds and the machine will automatically move to the loading
position. The yellow LED light will now be lit.
The loading position will adjust the machine to enable one of the
following procedures:
1. Insert or remove the bobbin case
2. Replace the latch wire
3. Replace the needle
10
" (2
5c
m)
IMPORTANT: The needle should be in the UP position, the thread cut, and the fabric removed before
setting machine to the loading position.
NOTE: The blue or green LED light will also be lit, depending on which needle position was select-
ed prior to pressing the positioning button for the loading position. If the presser foot is in the up
position or if the side door is open then the orange LED light will flash while the yellow LED is lit.
Yellow Mark
E
F