Baby Lock Sashiko 2 (BLQK2) Instruction and Reference Guide - Manual (Page 35)

M
A
I
N
T
E
N
A
N
C
E
34
Replacing Latch Wire
1. Press and hold the positioning button for approxi-
mately 2 seconds to set the machine to the loading
position. (Fig. A)
REMINDER: Remove fabric and cut thread before
putting machine into the loading position.
2. Lower the presser foot. (Fig. B)
3. To move the latch wire from in front of the needle,
grasp the latch wire lever and pull straight down,
turn the lever 90 degrees towards you and release.
Lever will remain in the down position. (Fig. C)
4. With screwdriver, loosen the latch wire screw by
turning it counterclockwise, then slide the latch wire
toward the left to remove. (Fig. D)
5. Slide the new latch wire onto latch wire screw until
the opening is completely against the screw.
Securely tighten the latch wire screw. (Fig. E)
6. Restore the latch wire to its original position. (Fig. F)
7. After restoring the latch wire, make sure it is in the
center channel of needle. (Fig. G)
B
C
D
E
F
G
A
Loading
Position
Positioning
Button