Baby Lock Sashiko 2 (BLQK2) Instruction and Reference Guide - Manual (Page 40)

A
P
P
E
N
D
I
X
39
Troubleshooting (cont.)
Fabric will not feed
through the machine:
1. Is the feed dog free of lint?
2. Is the presser foot pressure dial set right for the
fabric type?
3. Is the needle plate secure on the machine?
4. Is the presser foot height adjustment dial set
correctly for fabric type?
5. The stitch length and/or stitch spacing is not set
correctly for fabric type.
36
11
36
11
40/41
Stitch is unbalanced: 1. Is the bobbin thread tension adjusted properly for
thread weight?
2. Is the bobbin case threaded properly?
3. Is the bobbin case loaded properly?
4. Is the needle bent, broke, and/or worn?
5. Thread is knotted, tangled or of poor quality.
6. Spool cap is not properly attached and/or the
correct size for thread spool.
19
18
18
-
10
11/17
Condition Cause
See
page(s)
Bobbin Case Thread Jam
In the event thread would get jammed inside the bobbin case during sewing follow steps below
to clear machine:
1. Cut thread(s) close to fabric in order to clear the needle. This will help prevent possible
damage to the needle and/or latch wire.
2. Gently remove the fabric from under the presser foot.
3. Press positioning button to set machine to the loading position and open side cover.
4. Remove bobbin case with bobbin from machine. If necessary, carefully cut any threads that
may prevent you from removing bobbin case. Then refer to Cleaning the Shuttle Hook
(page 36) to clean any loose threads from shuttle area.