Basler Electric BE1-87G - Manual (Page 44)

Stabilizing Reactor
For three-phase relays, the stabilizing reactor consists of a module attached to the rear of the mounting
case. For projection mounting or convenience, the stabilizing reactor module can be removed and
relocated. To remove the stabilizing reactor, remove the four screws that secure the module to the
mounting plate. The mounting plate is separated from the case by removing the two hex-head bolts.
When the stabilizing reactor is relocated, it should be rewired in accordance with the connection diagrams
shown later in this section.
The overall dimensions of the stabilizing reactor are shown in Figure 4-13. A side view showing the
dimensions of a semi-flush mounting case with attached stabilizing reactor is provided in Figure 4-14.
4-14 BE1-87G Installation 9170800990 Rev N