Acronis True Image 9.1 Enterprise Server - User Guide - Manual (Page 107)

Copyright © Acronis, Inc., 2000-2007 107
/compression:[0…9]
Specify the data compression level.
It ranges from 0 to 9 and is set to 3
by default
Any
/split:[size in MB]
Split the backup into parts of the
specified size
Other than ASZ
General options
/oss_numbers
Declares that numbers of partitions
in the
/partition
option are
adjusted for MBR partition table
rather than be simple ascending
numbers. This means that primary
partitions have numbers 1-1, 1-2, 1-
3 (and 1-4 if there are not logical
partitions on the disk) and logical
partitions numbers start with 1-4.
For example, if the disk has one
primary and two logical partitions,
their numbers can appear as
follows:
/partition:1-1,1-2,1-3
or
/oss_numbers /partition:1-1,1-
4,1-5
Any
/reboot
Reboot the server after the
operation is completed
Any
/log:[file name]
Create a log file of the current
operation with the specified file
name
Any
15.1.3 Specific options (options specific for individual trueimagecmd
commands)
Option Description
create
/harddisk:[disk number]
Specifies the hard disks to include into the image file by numbers.
The list of available hard disks is provided by the
/list
command.
An image may contain data of more than one hard disk. In that
case, separate disk numbers by commas, e.g.:
/harddisk:1,3
/partition:[partition
number]
Specifies the partitions to include into the image file by numbers.
The list of available partitions is provided by
/list
. Partition
numbers are specified as <disk number>-<partition number>, e.g.:
/partition:1-1,1-2,3-1
/file_partition:[partition
letter]
Specifies the partition where the image file will be stored (by letter
or number). This option is used with
/filename:[file_name]
. In
that case the file name must be specified without drive letter or root
folder. For example:
/file_partition:D /filename:”\1.tib”