Acronis True Image 9.1 Enterprise Server - User Guide - Manual (Page 57)

Copyright © Acronis, Inc., 2000-2007 57
partitions must be included into the image. Any partitions which are missing from the image
will be lost.
If you want more functionality during restoration, write a standalone version of Acronis
True Image Workstation to the rescue disk. Then you will be able to configure the
restore task using Restore Data Wizard, use Acronis Snap Restore or Acronis Universal
Restore etc.
Under Advanced tab you can select full, safe or both Acronis True Image Workstation
loader version. The safe version does not have USB, PC card or SCSI drivers and is useful
only in case the full version does not load. If you want the computer, booted from the
media, to be accessible for remote control with Acronis True Image Management Console,
add Acronis Bootable Agent to the media. If you have other Acronis products, such as
Acronis Disk Director Suite, installed on your computer, the bootable versions of these
programs’ components will be offered as Advanced as well.
In case you check Do not place additional components if there is no free space box,
the program will try to write at least Acronis True Image Workstation to media, short of
space.
6.3.10 Additional settings
1. Validate backup archive upon operation completion
The preset is disabled.
When enabled, the program will check integrity of the just created or supplemented archive
immediately after backup.
To check archive data integrity you must have all incremental and differential backups
belonging to the archive and the initial full backup. If any of successive backups is missing,
validation is not possible.
2. Overwrite data on a tape without user confirmation
The preset is disabled.
A full backup, when created on a tape drive, overwrites all data stored on the tape (see
3.8
Backing up to tape drive for more information). In this situation, Acronis True Image
Workstation will warn that you are about to lose data on the tape. To disable this warning,
check the middle box.
3. Ask for first media while creating backup archives on removable media
The preset is enabled.
You can choose whether to display the Insert First Media prompt when backing up to
removable media. With the default setting, backing up to removable media may be not
possible if the user is away, because the program will wait for pressing OK in the prompt
box. Therefore, you should disable the prompt when scheduling a backup to removable
media. Then, if the removable media is available (for example, CD-R/RW inserted) the task
can run unattended.