Beurer PM 15 - Manual (Page 25)

25
• When the word „Beep“ appears in the display, you can choose whether to have the confirmation tone
(the „beep“) on or off using the Start/Stop or Reset buttons. If the confirmation tone is activated, a
short beep sounds every time a button is pressed.
• Once all data has been set, hold the MODE button down for 3 seconds to exit setting mode.
• If no buttons are pressed in setting mode within 60 seconds, the heart rate monitor automatically
reverts to time display.
8. heart rate measurement
• Fasten the monitor to your wrist.
• Place one finger on the sensor and hold it down for at least 5 seconds. Make sure that the
sensor at the back of the casing fits closely to the skin. At first, the display reads „---“.
• After 5 to 8 seconds, the heart rate reading is displayed.
• If the heart rate alarm is switched on, the relative heart rate is also displayed.
• If the measured heart rate is below the lower heart rate limit, this is indicated by an „L“. Any value
above the upper heart rate limit is indicated by an „H“.
• If, in pulse alarm mode, pulse limits according to age and gender have also not changed, the measured
heart rate in the fitness performance range (between 65% and 85% of the maximum heart rate) is
displayed graphically.
• 5 seconds after releasing the button, the heart rate monitor returns to the previous mode.
Advice and tips
1. Heart rate measurement is possible in any function mode.
2. One sensor is fitted on the back of the monitor casing. The sensor has to have constant, firm contact
with the skin.
3. Never measure heart rate under water.
date display