Cadac Seance - Manual (Page 26)

3-2 Séance
Séance Interface 7975 Revision SE2005-2
616 5HPVHUYH#PRGH
Remserve mode allows access to the Séance’s disk via the debug port on the rear
panel and a COM port on the PC. You need a ’NULL MODEM’ cable to establish com-
munications.
617 5HPRWH#PRGH
Remote mode allows access to DOS on the Séance box via the debug port on the
rear panel and a COM port on the PC. You need a ’NULL MODEM’ cable and a ter-
minal emulation program to establish communications.
618 6pDQFH#'LVSOD\#7UHH
Figure 3-2 shows a block diagram of the screens available in the séance program.
There are four screen types in the Séance program, each selectable from the main
menu. They are the option screens, error screens, status screens and version
screens.
FIG 3-2. Séance screens
CADAC Seance :Console = FTYPE Pc1 BNC
Restart Status Options Version Error
Seance ip address =194.222.033.010
exit prev next edit
Seance ip address 194.222.033.010
quit cursor - + save
Save new options
no options yes
Seance : 1.02 Nov 18 1999 12:11:58
quit version
CCM : 1.10
quit version
cue = 1.0 DXS
quit dynamic
SAM : ethernet message not received
quit more next
routine = check_ethernet_message ()
quit next
200P
quit
Main
Options
Options edit
Save options
Seance version
CCM version
Status
errors
extended error
dynamic
Restart the program
Save the options
Seance config : 10
quit version