Cloud Electronics 46-120 - CDI-46 - Manual (Page 20)

CDI-46 Installation and Setup Guide V1.0 20
Note that only an Installer may define Users and change their access privileges.
The flexibility of the security system allows a client – if they wish - to give particular members of staff access only to certain
zones and control functions. Level control and/or source selection for each zone, plus permission to initiate PM-SA messages
and mic access may be defined individually for each user.
To define User privileges, first enter a PIN in the
User PIN field and click Update. User enabled must be selected (green
tick) for the set of functions listed below to take effect. Select the zones for which the User should have access, and select
Level and/or Source according to requirements. If the User should be able to initiate announcements from a PM-SA paging
mic, select Messaging. If the User should have the authority to enable microphones in his/her allocated Zones, select Mic 1
and/or Mic 2 as appropriate.
Once User privileges have been defined, the User(s) may log on using their own PINs, and will be presented with page layouts
containing only those functions which their access privileges allow. An example is shown below, where User 3 has been given
access only to Zones 3 and 4 and can adjust level but not select music sources. Messaging is disabled (which should always be
the case if the system does not include a PM-SA paging mic), but the User can enable Mic Input 1 if required.