Datatek UTM - Manual (Page 50)

U T M U s e r ' s M a n u a l
01/18/08 50
Configuration #5
This is a sample ATM configuration. The entire T1 is used for ATM since the transport protocol for
ATM convergence requires it as such.
UTM
ATM
Network
DT-4000
The commands used to configure the Universal Trunk Module are as follows:
dsu type=t1 prof=s0 timing=net tsrate=64 addslot=all
trunk type=atm phy=dsu modtype=samsl vpi=0 vci=32
restore
The ATM network endpoint connected to the UTM must be configured to provide a circuit at the
administered VCC (VPI/VCI combination). This may be a different number than that presented to
the DT-4000 since it has only local significance.