Datatek UTM - Manual (Page 57)

U T M U s e r ' s M a n u a l
01/18/08 57
11 U
SING THE
UTM
AS A
CPM
The IP-CommKit software allows a UTM to be used as a CPM. This method of attaching
CommKit hosts does not require the host to be co-located. The UTM supports all of its transport
mechanisms for the connection, however the IP-CommKit has only implemented the IP-DSU
protocol.
Consider the following diagram:
U T M
T h e U T M a s a n IP -C o m m K it In terfa c e
N e tw o rk
C a rd
N o d e o r M P C C o m m K it
H o st
IP
N e tw o rk
1 0 B a s e T
Configuration of the UTM is as follows:
local ipaddr=<local_ip_address> submask=<subnet_mask>
gateway ipaddr=<gateway_ip_address>
trunk type=ipdsu modtype=CPM dest=<COMMKIT Host IP Address>
restore
In the example above, the IP network may be simply a cross-over cable, or span many routers.