DFI CR902-B - Manual (Page 12)

www.dfi .com Chapter 3 Hardware Installation
12
Chapter 3
System Memory
DDR3_2
Standby
Power LED
The system board is equipped with two 204-pin SODIMM sockets that support DDR3(1.5V)/
DDR3L(1.35V) memory modules; depends on CPU supported. However, DDR3L memory mod-
ule can run at 1.5V.
DDR3_1
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the board.
Power-off the PC then unplug the power cord prior to installing any devices. Failure to
do so will cause severe damage to the board and components.