DFI CR902-B - Manual (Page 33)

www.dfi .com Chapter 4 BIOS Setup
33
Chapter 4
ACPI Power Management Configuration
This section is used to configure the ACPI Power Management.
ACPI Sleep State
Selects the highest ACPI sleep state the system will enter when the Suspend button is
pressed.
S1(POS) Enables the Power On Suspend function.
S3(STR) Enables the Suspend to RAM function.
Resume by PME
Enable this field to use the PME signal to wake up the system (via PCIE and onboard
(LAN).
Resume by RTC Alarm
When Enabled, the system uses the RTC to generate a wakeup event.
Select ACPI sleep state
the system will enter when
the SUSPEND button is
pressed.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1227. Copyright (C) 2012 American Megatrends, Inc.
ACPI Settings
ACPI Sleep State
Resume by PME
Resume by RTC Alarm
Advanced
[S3 only (suspend to...]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
PC Health Status
This section displays hardware health monitor.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1227. Copyright (C) 2012 American Megatrends, Inc.
System Hardware Monitor
CPU Smart Fan
CPU Temperature
CPU FAN Speed
VCore
VCCRTC
DDR
+1.05V
CPU
VCCSA
Advanced
[Enabled]
: +51 C
: N/A
: +0.944 V
: +3.390 V
: +1.492 V
: +1.046 V
: +0.803 V
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Enable/ Disable CPU
SmartFan