DFI HM920-HM86 - Manual (Page 25)

www.dfi .com Chapter 3 Hardware Installation
25
Chapter 3
Standby Power LED
Standby
Power LED
This LED will light when the system is in the standby mode.
Cooling Option
Heat Spreader with Heat Sink and Fan
• “1” and “2” denote the locations of the thermal
pads designed to contact the corresponding compo-
nents that are on HM920-QM87/HM86.
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto HM920-QM87/HM86.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
Top View of the Heat Sink
Bottom View of the Heat Sink
1
2