DFI BT160 - Manual (Page 25)

www.dfi .com
25
Chapter 2 Hardware Installation
Chapter 2
SATA (Serial ATA) Connectors
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
• 2 Serial ATA 2.0 ports
- SATA 0 and SATA 1 ports with data transfer rate up to 3Gb/s
- One multiplexed with mSATA (Mini PCIe)
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“IDE Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
Features
SATA 1
SATA 0
SATA 2.0 3Gb/s
(SATA port 0 provides adequate
space for SATA DOM.)
SATA (Serial ATA) Power Connectors - BT161
SATA
Power 0
SATA
Power 1
+12V
+5V
Ground
1
Ground
4
These SATA power connectors supply power to the SATA drive. Connect one end of the pro-
vided power cable to the SATA power connector and the other end to your storage device.