Assigning the target modules to a scanmode set – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 46
Switching the target modules automatically or manually
38 · G&D DVICenter
Assigning the target modules to a scanmode set
How to assign target modules to a scanmode set or cancel the existing assignment:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press
F10
to call the Personal Profile menu.
3. Select the
Scanmode set
entry and press
Enter
.
4. Press
F5
to edit the selected scanmode set.
5. Select the
Members
entry and press
Enter
.
The Scanmode Set Members menu opens. This menu lists all target modules within
the matrix system that you are allowed to access.
6. Mark a target module to be assigned to the scanmode set or whose assignment is
to be cancelled.
7. Press
F8
to (de)activate the selection.
8. If you want to assign further target modules to the scanmode set, repeat steps 6 and 7.
9. Press
F2
to save your settings.
NOTE:
Global scanmode sets can only be edited by users with activated Superuser
right (see page 50).
Without this right, only the assigned target modules can be viewed.
ADVICE:
Use the menu’s search function, the view filter or the sort criteria (see
page 9 ff.) to limit the selection of list entries.
NOTE:
The target module that has been assigned to the scanmode set is marked
with an arrow ().