HiTi CS-200e User Manual
Page 9
1.3.2 Printer Connecting ( Power / USB / Modules )
Power
USB
a. Connect power cable to power adaptor, then plug the power connector to printer’s power socket
b. Plug the power plug to an earthed power socket
c. Switch ON from the ON/OFF button to power up the printer, then the LCM control panel should light up
and display “ready” message which indicates the printer is under working condition.
Refer to the print driver installation section of this user guide for more details,
and follow the instruction carefully.
07
English
Please make sure the power plug is connected into a properly protected and earthed
electrical source.
Please make sure the print driver software is fully installed before
connecting the USB cable to your printer device.
For your own safety, please make sure the power cable is always unplugged before attempting
any service maintenance work.
a
b
c
d
READY
HiTi CS-200e & CS-220e user manual
d. Please power off the printer and unplug power cord before installing any of modules so that printer
won’t get damaged.