IDK OPF-H1000D - Manual (Page 19)

OPF-TH1000D/OPF-RH1000D User’s Guide
19
5.3 Application example
Digital video and audio are transmitted from the Blu-ray disc player to the transmitter. The transmitter sends
those signals to the receiver over a fiber optic cable, and it also converts digital audio signals to analog and
outputs them to the amplifier. The receiver outputs the received video and audio signals to the projector from
the HDMI output connector.
You can control peripheral devices (such as projectors) by using a control device (such as PCs).
Note: The OPF-TH1000D must be paired with OPF-RH1000D. The OPF-H1000D cannot be connected to an
I/O slot board of the FDX series or other models of the OPF series.
Projector
Speakers
Blu-ray disc player
Amplifier
RS
-232
C
FG
DC
5 V 3 A
L AUDIO OUTPUT
R
POWER STATUS HDCP
HDMI INPUT
Tx
OPTICAL DAISYCHAIN Tx for HDMI OPF-TH1000D RX
OPTICAL
TX
CLASS 1 LASER PRODUCT クラス 1 レーザ製品
KEY LOCK － ＋ SET
SIGNAL
RS
-232
C
FG
DC
5 V 3 A
POWER STATUS HDCP
HDMI OUTPUT
Rx
OPTICAL DAISYCHAIN Rx for HDMI OPF-RH1000D RX
OPTICAL
TX
SIGNAL
DIP SW
CLASS 1 LASER PRODUCT クラス 1 レーザ製品
Laptop
Source and sink devices are connected
Notes:
● Make sure to plug the dust caps into the following two connectors to which a fiber optic cable is not
connected: a transmitter connector for extension (right end) and an I/O connector for extension of the last
receiver (left end).
● Cut the attached dust cap in half before pulling them to connectors.