IDK OPF-H1000D - Manual (Page 40)

OPF-TH1000D/OPF-RH1000D User’s Guide
40
8 Command
You can set the transmitter and receiver using the RS-232C connector. Setting mode need to be set for the
target device (transmitter or receiver); see “6.4 Setting transmitter and receiver using setting mode” for
details.
【See 6.4 Setting transmitter and receiver using setting mode】
8.1 Command outline
Each command consists of 3-byte character (case ignored) following “@” (“40” in hex) and a parameter
(one-byte number). Some commands do not need a parameter or can specify several parameters.
Commands can be run by sending the delimiter, (CR+LF; “0D+0A” in hex).
Example: @SPM,2
“,” (“2C” in hex) is the delimiting character between a command and parameter and between parameters.
8.2 Command list
Error status
Command Function Page
@ERR Error status 41
Setting command
Command Function Page
@GPM / @SPM Setting time for ignoring video output request signals:
Hot Plug mask off setting (only receiver)
42
@GIV Acquiring version information 42
Status acquire command
Command Function Page
@GIS Acquiring input status 43
@GOS Acquiring output status 44