Measurement Computing ADLIB WIN - Manual (Page 187)

Chapter 44 Board Driver Error Codes 31-5
DRVERR_EXPPANEL_MAXLEN = -401401 The specified expansion panel gain list is
invalid.
DRVERR_EXPPANEL_ARRAY_PTR = -401402 Invalid expansion channel gain list.
DRVERR_CJLIST_MINLEN = -401500 The specified CJ list is invalid.
DRVERR_CJLIST_MAXLEN = -401501 The specified CJ list is invalid.
DRVERR_CJLIST_ARRAY_PTR = -401502 Invalid CJ list.
DRVERR_ADLOWRATE = -401600 The specified A/D Clocking rate is low.
DRVERR_ADWITHTC_RATEHIGH = -401601 The desired A/D clocking rate with
thermocouple expanders is too high.
DRVERR_DAOUTRANGE = -401700 Invalid D/A range specified.
DRVERR_DA_NOTAVAILABLE = -401701 D/A support is not available.
DRVERR_DAUNITS_INVALID = -401702 The specified D/A unit is not available.
DRVERR_IRQ_INUSE = -401800 The specified Interrupt level is already in use.
DRVERR_INTERRUPTS_NOTSUPPORTED = -401801 Interrupts are not supported.
DRVERR_DMA_INUSE = -401900 The specified DMA level is already in use.
DRVERR_DMA_NOTSUPPORTED = -401901 DMA is not supported.
DRVERR_DMA_TRANSFER= -401902 DMA Transfer Error.
DRVERR_ADFIFO_OVERRUN = -402000 The board's A/D FIFO overrun bit has set.
DRVERR_BURST = -402001 The board's A/D Burst error bit has set.
DRVERR_CLOCK = -402002 The board's A/D Clock error bit has set.
DRVERR_ADDATA_OVERRUN = -402003 The board's A/D DATA overrun bit has
set.
DRVERR_TRIGGER_OVERRUN = -402004 The board's trigger overrun bit has set.