MMD Equipment 185S-5C2 part 1 - Manual (Page 12)

1.Safety
1-9
A100285

Be sure to stop the engine, and let the coolant water
sufficiently cool down before draining it.

If the drain valve is opened before the coolant water is
cooled enough, hot water could jet out, and it could cause
scalding.

After stopping the engine, wait for 10 to 20 minutes until
the engine oil cools off. Then check the level of the engine
oil, or refill or drain the oil.

The engine oil is very hot during operation and just after it
stops. Be careful because the hot oil also pressurized
blows off and it can cause burning.

Be sure to perform the periodical check of compressor oil
and oil separator.

Neglecting checks could cause overheat of the oil,
resulting in a fire.

Waste liquid from the machine contains harmful material.
Do not discharge it onto the ground or into the river, lake or
sea. Such material will contaminate the environment.

Be sure to use a container to hold the waste liquid from the
machine.

Be sure to follow the designated regulations when
disposing of oil, fuel, coolant (antifreeze), filter, battery or
other harmful materials.
Opening coolant water drain valve cap
H990432
Refilling or draining of engine oil
H990432
Fear of fire
H990433
Treatment of organic wastes