MMD Equipment 185S-5C2 part 1 - Manual (Page 32)

4. Operation
4-14
4.5 Stopping
The unit is equipped with a built-in check valve. Therefore, some pressure will be left in pipes after the
unit stops. Be sure to release such residual pressure from the pipes by opening the air valve gradually
after the unit stops.
<Procedure>
① Close the air valves completely and operate the machine about 5 minutes, until it cools down.
② Turn the starter switch to “STOP” position to stop the engine.
③ Remove the key from the compressor every time when you stop the engine. Keep the key and be
careful not to lose it.
4.6 Air Bleeding in fuel pipe
Should the machine stop due to the shortage of fuel, perform the air bleeding operation
according to the following procedures.
<Procedure>
① Replenish fuel.
② Turning the starter switch to “RUN” position, the electromagnet pump functions to bleed the
air in fuel pipe system automatically.
③ The air bleeding operation can be finished within 1 minuite.