Montigo P42DF - Manual (Page 23)

Section 8: Installing the Accessories
Installing the Firestones
The P42DF* is supplied with firestones. Remove the
Door as shown in the previous Instruction. Follow these
instructions to ensure all parts are removed or replaced
as required. Once the glass door is removed place the
firestones randomly across the pan and the burners as
described in Figure 24 to 24f.
Note: Only cover the burner with one layer of designer firestones.
Figure 24b. Installation of the firestones. (Ensure ONLY one
layer of firestones cover the surface).
Figure 24c. Spreading the firestones evenly and make sure
there are no firestones covering the pilot .
Figure 24. Up-lighting glass in package.
Figure 24a. Place the up-lighting glass in the burner tray.
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
Installing the Door:
Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
Figures 23f. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 23f. Removing and installing the glass doors.
Removing the Door:
WARNING
When installing the fireplace - gas lines, fittings,
accessories or any other objects cannot impede the
proper movement of the door buckles.
Page 23
P42DF* Indoor Gas Fireplace
XG0195 -150204.2
Installation