OnLine Power Telecommunication - Manual (Page 43)

OnLine Power
4-3
REV A
• Remove the Hold Down bracket at each side of the Battery.
• ALL BATTERY WORK SHOULD BE PERFORMED ON THE GROUND AS BATTERY CAN
WEIGH OVER 80 LBS. HANDLE CAREFULLY.
• Carefully slide the Battery out of the cabinet. Carefully disconnect the battery terminals, insulate
wiring lugs using electrical tape.
4-6 REPLACING BATTERY
• Replace the new battery (same type as the one removed) and connect its terminals.
WARNING!
REINSTALL THE THERMOPROBE AT THE SAME BATTERY TERMINAL IF IT
WAS REMOVED EARLIER.
• Slide the battery in its location. Connect the battery cables and torque the terminals.
• Reinstall the front hold down bracket.
• Reconnect J2, J3, and J5 in front, for Battery Power, Thermoprobe and Battery Heaters
respectively.