OnLine Power Telecommunication - Manual (Page 5)

d
OnLine Power
CAUTION
A battery can present a risk of electrical shock and high short
circuit current. The following precautions should be observed
when working on batteries:
1) Remove watches, rings, or other metal objects.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4) Do not lay tools or metal parts on top of batteries.
5) Disconnect charging source prior to connecting or disconnecting battery terminals.
6) Determine if the battery is inadvertently grounded. If inadvertently grounded, remove source of
ground. Contact with any part of a grounded battery can result in electrical shock. The likelihood
of such shock will be reduced if such grounds are removed during installation and maintenance
(applicable to a UPS and a remote battery supply not having a grounded supply circuit).
DANGER!!
“HIGH VOLTAGE 96 VDC” LABEL LOCATED NEAR BATTERY JACK ON
FRONT PANEL OF ELECTRONIC TRAY.
WARNING!
ENSURE CONNECTOR P3 / J3 ARE ALWAYS CONNECTED.
FAILURE TO COMPLY WILL OVERCHARGE AND DAMAGE BATTERIES.
WARNING!
LABEL NEAR BATTERY AND ON DOOR INDICATES, “BATTERY IS
HEAVY”. EACH BATTERY WEIGHTS 82 LBS. TWO PERSONS AND
CAUTION ARE REQUIRED WHEN REMOVING BATTERY FROM CABINET.